For use in the CZ P-10 S, C, and F 9mm models only

This kit is designed to be used with the CZ factory #19 trigger bar and later. Using one of the earlier iterations (#16, #17 or #18) will not perform as desired. Please contact CZ to order a replacement trigger bar.

Not compatible with the CZ P-10 in .45ACP or the CZ P-10 Micro

From the Designers:

Thank you for your interest in our Action Enhancement Kit for the CZ P-10 family of pistols.

Our kit, if you install all the included components, will yield a smooth rolling trigger break (similar to a Glock) but WELL under 4 lbs. with reduced over travel. Because it uses no aftermarket springs, ignition is not compromised.

Our design was geared toward competition pistol events and for those who have reduced hand strength, or anyone who feels the stock pull weight (and trigger body) might affect their performance with the pistol.

Our flat faced Aluminum trigger provides a more comfortable positioning of the trigger finger for most users with less chance of abrasion from the lower portion of the trigger guard. The flat trigger also allows you to take advantage of better leverage over a pivoting trigger system. This is why installers will likely record lower trigger pull measurements than what we report.

If you use the factory disconnector instead of ours, the pull weight and trigger break characteristics will remain relatively unchanged when compared to the factory configuration. In this configuration, the benefit of our trigger design will become apparent – especially in extended shooting sessions.

Regardless of which disconnector you install, you must use our slide cover plate in conjunction with our trigger.

As part of the design team that brought this product to life, I hope that this kit meets or exceeds your expectations.

Sincerely,

Randy Lee